Which engine mount for Webra 1.20
11-25-2005 | 08:37 AM
#1
Thread Starter
My Feedback: (2)
Joined: Feb 2002
Posts: 393
Likes: 0
Received 0 Likes
on
0 Posts
From: Hastings, NE
Which engine mount for Webra 1.20
I am looking for a mount for a Webra 1.20. I want a basic mount either glass or aluminum. I looked at the Dave Brown 1.20 mount but am not sure it is quite big enough. The Webra is 48 mm wide. I can't seem to find much in this size. Thanks.
11-25-2005 | 01:04 PM
#2
My Feedback: (16)
RE: Which engine mount for Webra 1.20
THese are nice and strong and seem to hold up well for me. I've never broken one.
http://www2.towerhobbies.com/cgi-bin...&I=LXATG7&P=ML
Enjoy,
Jim
http://www2.towerhobbies.com/cgi-bin...&I=LXATG7&P=ML
Enjoy,
Jim
12-13-2005 | 08:39 AM
#3
Thread Starter
My Feedback: (2)
Joined: Feb 2002
Posts: 393
Likes: 0
Received 0 Likes
on
0 Posts
From: Hastings, NE
RE: Which engine mount for Webra 1.20
Jim,
Thanks for the reply. Could you give me the width between the beams on this mount. Tower has it listed as 3.25 to 4.5 inches. That can't be correct. I need 48 mm between the arms for the Webra 1.20.
Thanks for the reply. Could you give me the width between the beams on this mount. Tower has it listed as 3.25 to 4.5 inches. That can't be correct. I need 48 mm between the arms for the Webra 1.20.
