Moki 2.10 Why?
11-21-2002 | 01:37 PM
#1
Thread Starter
Senior Member
My Feedback: (17)
Joined: Oct 2002
Posts: 2,320
Likes: 0
Received 0 Likes
on
0 Posts
From: Cressona, PA
Moki 2.10 Why?
I Just installed my moki 2.10 onto my wm extra300. I put the spinner backplate on then an apc 20x10 prop then the supplied washer and nut. There is no threads left. How am I supposed to install a spinner adapter nut? Am I missing something here? I cant believe that Moki wouldnt make the shaft long enough to accomodate this setup as i'm sure it is quite common. Please advise.
11-21-2002 | 01:46 PM
#2
My Feedback: (14)
Joined: Feb 2002
Posts: 95
Likes: 0
Received 0 Likes
on
0 Posts
From: Oconomowoc,
WI
Moki Spinner Adapter
Moki has a spinner adapter nut available that works perfectly. I think you can get it from Horizon or Jim Gerard (Moki Importer) but I don't have Jim's e-mail address.
11-21-2002 | 02:02 PM
#3
Thread Starter
Senior Member
My Feedback: (17)
Joined: Oct 2002
Posts: 2,320
Likes: 0
Received 0 Likes
on
0 Posts
From: Cressona, PA
Moki 2.10 Why?
How does the spinner adapter attach to the engine? Like i said there are no threads sticking out past the supplied nut. Or does the adapter take the place of the nut? Oh and thanks I will check out horizon.
