MDS .68 Tuned pipe
05-02-2006 | 02:56 PM
#1
Thread Starter
Senior Member
Joined: Mar 2006
Posts: 1,549
Likes: 0
Received 0 Likes
on
0 Posts
From: Geraldton, AUSTRALIA
MDS .68 Tuned pipe
I recently was given a fairly new MDS .68 which was in a lawn dart incident and had the exhaust snapped off near the flange.
Just wondering if there are any manufacturers out there who sell the manifold for this engine so I can put a tuned pipe on it. If I had a TIG I would make one myself, but I have very limited workshop access and my garden shed is not big enough to swing a kitten in.
I expect a few "Get rid of it and buy an O.S" comments, but I already have a couple of O.S's and Enya's and even an old Bluebird N.S so I want to get the .68 going.
Actually if anyone has a stock exhaust for one of these and wants to get rid of it let me know. I will organise to have it frieghted to aus.
Would prefer a tuned pipe, but beggars can't be choosers.
Just wondering if there are any manufacturers out there who sell the manifold for this engine so I can put a tuned pipe on it. If I had a TIG I would make one myself, but I have very limited workshop access and my garden shed is not big enough to swing a kitten in.
I expect a few "Get rid of it and buy an O.S" comments, but I already have a couple of O.S's and Enya's and even an old Bluebird N.S so I want to get the .68 going.
Actually if anyone has a stock exhaust for one of these and wants to get rid of it let me know. I will organise to have it frieghted to aus.
Would prefer a tuned pipe, but beggars can't be choosers.
