Webra Silverline vs. Blackhead
11-03-2007 | 05:17 AM
#2
Senior Member
My Feedback: (3)
Joined: Dec 2004
Posts: 1,486
Likes: 0
Received 0 Likes
on
0 Posts
From: Martinsville,
IN
RE: Webra Silverline vs. Blackhead
I think I read sometime back the silverline had cheaper factory bearings, less compression and something different about the carb . I'm no expert but I do have older Speed webra's....
11-03-2007 | 10:38 AM
#3
RE: Webra Silverline vs. Blackhead
The Silverline is the one with the un-bushed rod too....correct? I think we were just talking about that somewhere...in your thread about the connecting rod?
11-03-2007 | 06:52 PM
#4
Senior Member
Joined: Mar 2002
Posts: 309
Likes: 0
Received 0 Likes
on
0 Posts
From: sydney, AUSTRALIA
RE: Webra Silverline vs. Blackhead
The Blackhead had a needle bearing on the conrod LITTLE end. The Silverline did not.
That was the main difference although there were many small changes made over the length of production. The Blackhead was produced in Berlin for almost 30 years and not moved to Austria with the other engines.
That was the main difference although there were many small changes made over the length of production. The Blackhead was produced in Berlin for almost 30 years and not moved to Austria with the other engines.
