OS max 60SR
#1
Junior Member
Thread Starter
Join Date: Jun 2003
Location: Nova Scotia, Canada
Posts: 13
Likes: 0
Received 0 Likes
on
0 Posts
OS max 60SR
I have an OS max 60SR thats in need of some parts. Only thing is that OS has discontinued the engine. I dont have a parts break-down of the engine so i dont know any P/N. Can anyone out there help!!!!!!!!!!!!!!!!!!
#4
Junior Member
My Feedback: (1)
Join Date: Apr 2002
Location: Delta,
BC, CANADA
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
OS Parts
Hey Flyboy Dave, some of us do. I was able to help you out.
You can still get parts from Great Hobbies or Tower. The piston, ring, bearings, and gasket set are still available. Its the cylinder and crankshaft the the hard ones to get.
Piston # OS26703210 (it is the same piston as the 60FSR)
Ring # OS 26703404
Front Bearing # OS 26731002
Rear Bearing OS # 26730109
Gasket set # OS 26714006
You can still get parts from Great Hobbies or Tower. The piston, ring, bearings, and gasket set are still available. Its the cylinder and crankshaft the the hard ones to get.
Piston # OS26703210 (it is the same piston as the 60FSR)
Ring # OS 26703404
Front Bearing # OS 26731002
Rear Bearing OS # 26730109
Gasket set # OS 26714006
#5
My Feedback: (21)
Bob "A".....
...we must have posted at the same time....
Were ya' been....? I lost your e-mail address last fall
(I think)....in the "Great Computer Crash" when my
old PC flamed out for good....
Just yesterday....a Guy Pm'ed me and wanted to know
the balance point on a model....and when I was diggin'
through some maunuals and stuff, I came across that letter
you sent me with the OS 7L carb specs....
....I was gonna drop you a line, and see if you were still
around.... I've been at this site exclusively since last
June....
Speaking of FSR's....I just got this from an RCU member.
Should be here tomorrow....
Were ya' been....? I lost your e-mail address last fall
(I think)....in the "Great Computer Crash" when my
old PC flamed out for good....
Just yesterday....a Guy Pm'ed me and wanted to know
the balance point on a model....and when I was diggin'
through some maunuals and stuff, I came across that letter
you sent me with the OS 7L carb specs....
....I was gonna drop you a line, and see if you were still
around.... I've been at this site exclusively since last
June....
Speaking of FSR's....I just got this from an RCU member.
Should be here tomorrow....