RCU Forums - 2 Stroke engine help

RCU Forums (https://www.rcuniverse.com/forum/)

- Glow Engines (https://www.rcuniverse.com/forum/glow-engines-114/)

- - 2 Stroke engine help (https://www.rcuniverse.com/forum/glow-engines-114/1553206-2-stroke-engine-help.html)

Quick 1

02-22-2004 12:11 PM

2 Stroke engine help

Hello, I need some help on the low end needle adjustment setting and where is a good place to start? The motor is an os max .25! Any help would be greatfull thanks!!!

sandal

02-22-2004 05:24 PM

RE: 2 Stroke engine help

You should get it started if you adjust the air bleed screw to cover half the hole.

If it sounds rough and quits idling after a while, turn the screw out 1/4 of a turn and try again until it idles well. If it dies when you hit the throttle, turn the screw in 1/4 of a turn.

I don't have experience with old engines like the Max .25, but this method works well with LAs and FPs, and their carburettors are similar. Hope it helps.

Quick 1

02-24-2004 09:20 AM

RE: 2 Stroke engine help

Thank you very much!

All times are GMT -8. The time now is 04:07 PM.