RCU Forums - Help with Rossi Engine

RCU Forums (https://www.rcuniverse.com/forum/)

- Glow Engines (https://www.rcuniverse.com/forum/glow-engines-114/)

- - Help with Rossi Engine (https://www.rcuniverse.com/forum/glow-engines-114/8045574-help-rossi-engine.html)

europatc74

10-13-2008 04:07 PM

Help with Rossi Engine

Acquired a Rossi 40 rear exhaust crank case. On the side of the case is the word Morris. I have been looking for a sleeve and piston for this case with no luck. As I stated this is a rear exhaust front intake case. The piston sleeve aligning pin is on the right side of the case. Anyone have any info regarding this case and where parts can be found?? Thanks for any assistance. Dave

djlyon

10-13-2008 05:38 PM

RE: Help with Rossi Engine

Try this guy.

http://shop.vendio.com/RossiEnginesUSA

europatc74

10-13-2008 05:53 PM

RE: Help with Rossi Engine

Been there. The sleeve that they sell fits side exhaust. The sleeve positioning notch is above the exhaust port which would position the port to the side and not to the back where I need it.

lfinney

12-08-2008 10:13 AM

RE: Help with Rossi Engine

align sleeve as needed then mark sleeve and cut new notch, or just remove pin

anuthabubba

12-08-2008 10:34 AM

RE: Help with Rossi Engine

That might work for the sleeve (depends on ports) but the piston skirt cutouts could be a problem as well as the wrist pin if it's hollow.

Terry in LP

All times are GMT -8. The time now is 07:53 AM.