Axe CX Micro 3 in 1
10-23-2009 | 11:29 AM
#1
Thread Starter
Joined: Jul 2006
Posts: 144
Likes: 0
Received 0 Likes
on
0 Posts
From: Miami, FL
Axe CX Micro 3 in 1
Hey Guys,
I have an Axe CX Micro and I think the rx may be dead. I have had this heli for a few months now and have crashed and rebuilt in at least 50 times. After the last crash the tx will not control the servos or motors. The little led on the mixing board lights up but nothing else works. Is there anyway to test the board? Anywhere to get a cheap board? I have seen them on ebay for about 40 but I could just by a new heli for close to that.
I have an Axe CX Micro and I think the rx may be dead. I have had this heli for a few months now and have crashed and rebuilt in at least 50 times. After the last crash the tx will not control the servos or motors. The little led on the mixing board lights up but nothing else works. Is there anyway to test the board? Anywhere to get a cheap board? I have seen them on ebay for about 40 but I could just by a new heli for close to that.
