Old Multiplex 2010 programming information
11-20-2012 | 01:52 PM
#1
Thread Starter
Junior Member
Joined: Jun 2012
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
From: Cambridge, UNITED KINGDOM
Old Multiplex 2010 programming information
Hi
I have a Multiplex 2010 transmitter that I still use for some models. It is my only PCM enabled Tx as my main Tx is a Cockpit MM and I still have a number of PCM receivers installed in models. I have lost the manual for this unit and wondered if there was any kind soul who would scan the programming pages of the manual for me.
I would also like to upgrade this much loved unit. Is there any route to increase the number of mixers and to fit the 2 sliders that the 2010 is lacking. I have already added 3 of the 4 possible switches.
I have a poor scan of the 2020 manual (from the MPX site)
Regards
Mike
I have a Multiplex 2010 transmitter that I still use for some models. It is my only PCM enabled Tx as my main Tx is a Cockpit MM and I still have a number of PCM receivers installed in models. I have lost the manual for this unit and wondered if there was any kind soul who would scan the programming pages of the manual for me.
I would also like to upgrade this much loved unit. Is there any route to increase the number of mixers and to fit the 2 sliders that the 2010 is lacking. I have already added 3 of the 4 possible switches.
I have a poor scan of the 2020 manual (from the MPX site)
Regards
Mike
