Eclipse 7 - dual elevator
09-16-2003 | 09:12 PM
#1
Thread Starter
Junior Member
Joined: Feb 2003
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
From: Québec,
QC, CANADA
Eclipse 7 - dual elevator
I've tried everything and I always end up with the same problem.
PMX 3
Master 2
Slave 7
%100 and %100
Problem:
When I move the elevator stick up, both elevators go down. The travel is the same for both elevators.
When I move the elevator stick down, both elevators go up but the travel of the one on channel 7 is about 90% of the master elevator (channel 2).
What is that problem?
I've tried channel 2 and 5, same problem.
Thanks.
PMX 3
Master 2
Slave 7
%100 and %100
Problem:
When I move the elevator stick up, both elevators go down. The travel is the same for both elevators.
When I move the elevator stick down, both elevators go up but the travel of the one on channel 7 is about 90% of the master elevator (channel 2).
What is that problem?
I've tried channel 2 and 5, same problem.
Thanks.
09-17-2003 | 05:44 PM
#2
Senior Member
My Feedback: (1)
Joined: Jan 2002
Posts: 3,531
Likes: 0
Received 0 Likes
on
0 Posts
From: Poway, CA
RE: Eclipse 7 - dual elevator
I'm not sure... I know the trims don't link though, that is why I use a Y-harness in my Kangke TX Hurricane for the dual elevator set up.
Mike.
Mike.
