Programmer question
01-06-2004, 12:58 AM
#1
Senior Member
Thread Starter
Join Date: Jan 2002
Location: Calgary, AB, CANADA
Posts: 400
Likes: 0
Received 0 Likes
on
0 Posts
Programmer question
I tried to use my programmer to check the pulse width coming from my rx so I could set up my servos, and I think I may have a problem with the programmer. I'm using a Futaba 149DP rx, and I couldn't get any reading of the pulse width. It stayed at zero. Am I doing something wrong here, or is there something wrong with my programmer?
Jim
Jim
