HFP-10 V1.03
#1
Senior Member
Thread Starter
Join Date: Aug 2002
Location: Nuneaton, UNITED KINGDOM
Posts: 178
Likes: 0
Received 0 Likes
on
0 Posts
HFP-10 V1.03
Hi Mike
I have 5475HB servos marked MAR02 and some new 5625MG servos bought in the USA marked V1.03.
When the HFP-10 programmer does a reset, does it reload the firmware in the servos? if so to what version?
is MAR02 later than V1.03 or are they the same?
John
I have 5475HB servos marked MAR02 and some new 5625MG servos bought in the USA marked V1.03.
When the HFP-10 programmer does a reset, does it reload the firmware in the servos? if so to what version?
is MAR02 later than V1.03 or are they the same?
John
#2
My Feedback: (31)
RE: HFP-10 V1.03
See the link below for complete information:
http://hitecrcd.com/product_fs.htm
The programmer can reset the operating parameters, but is limited by its specific software revision. When the programmer is powwered up it will display its software revsion thereof. V1.03 is the latest revision available at this time.
Mar 02 and later dated equipment is comprised of revision V1.03.
http://hitecrcd.com/product_fs.htm
The programmer can reset the operating parameters, but is limited by its specific software revision. When the programmer is powwered up it will display its software revsion thereof. V1.03 is the latest revision available at this time.
Mar 02 and later dated equipment is comprised of revision V1.03.