Digital Torque
01-20-2003 | 05:50 PM
#1
Thread Starter
Junior Member
Joined: Jan 2003
Posts: 1
Likes: 0
Received 0 Likes
on
0 Posts
From: Carlisle, PA
Digital Torque
Three questions:
1. Is Hi-Tec planning any larger digitals? The HS-5735 is too small by about half. We need about 300 actual oz-in. We are experimenting with the HS-5735 board with a HS-815 motor & gear train. Results not in. We are prototyping right now but hope to be manufacturing in moderate quantities in two years.
2. Do the digitals have a motor protection circuit that shuts off current if the draw gets too high? (they seem to).
Joseph Osborne
1. Is Hi-Tec planning any larger digitals? The HS-5735 is too small by about half. We need about 300 actual oz-in. We are experimenting with the HS-5735 board with a HS-815 motor & gear train. Results not in. We are prototyping right now but hope to be manufacturing in moderate quantities in two years.
2. Do the digitals have a motor protection circuit that shuts off current if the draw gets too high? (they seem to).
Joseph Osborne
01-21-2003 | 11:30 PM
#2
Senior Member
My Feedback: (1)
Joined: Jan 2002
Posts: 3,531
Likes: 0
Received 0 Likes
on
0 Posts
From: Poway, CA
Digital Torque
Not at this time. You could probably get away with running it on 7.2V for the extra power you need but it will reduce the life of the servo.
No, there is no motor protection. At least, not that I know of.
Mike.
No, there is no motor protection. At least, not that I know of.
Mike.
