Eclipse 7 - moving channel 3 assignment
I am helping a friend set-up a scale sailplane. He has been looking at an Eclipse 7 as an upgrade from his Futaba 6XAS.
here is what he wants to do. R Aileron 1 Elevator 2 Tow release - 3 (assigned to a switch) throttle stick ( used to contol landing mixes) Rudder 4 R Flap 5 L Flap 6 L Aileron 7 Is this set-up possible with the Eclispe 7? If not, can you suggest an alternative set-up? If so, how can I take channel 3 off the throttle stick and assign channel 3 to a switch to operate the tow release? We have enough channels, if we can move 3 to a switch. Thanks! |
RE: Eclipse 7 - moving channel 3 assignment
On the Eclipse the assignments will be as follows:
channel 1- right aileron chennel 2- elevator channel 3- tow release (controlled by elevator D/R switch) channel 4- rudder channel 5- left aileron channel 6- right flap channel 7- left flap (channels 6 and 7 are controlled by what would normally be the throttle stick for landing or crow function on a glider) |
RE: Eclipse 7 - moving channel 3 assignment
Thanks! Can you tell me where in the manual this is documented? Not my radio, so I don't have the book.
You just solved a BIG problem for us. |
RE: Eclipse 7 - moving channel 3 assignment
Page 8 in the manual under the glider heading shows these channel assignments.
|
RE: Eclipse 7 - moving channel 3 assignment
You are the best! Hitec always comes through. And so many people told me this could not be done.
Way to go! |
All times are GMT -8. The time now is 11:18 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.