RCU Forums - EPA and elevon mixing,

RCU Forums (https://www.rcuniverse.com/forum/)

- Hitec/MultiPlex Radios- Ask Hitec Customer Service (https://www.rcuniverse.com/forum/hitec-multiplex-radios-ask-hitec-customer-service-53/)

- - EPA and elevon mixing, (https://www.rcuniverse.com/forum/hitec-multiplex-radios-ask-hitec-customer-service-53/3225139-epa-elevon-mixing.html)

Splatz

08-02-2005 05:32 PM

EPA and elevon mixing,

I have a Hitec Flash 5 SX and a 555 RX. I was trying to limit servo travel, I'm using 2 HS-81 servo's in channel 1 and 2 with elevon mixing on. When I set all channel EPA's to 60% I see the travel is not the same for each servo. What am I doing wrong?

Thanks,
Rick O,

mglavin

08-03-2005 03:27 PM

RE: EPA and elevon mixing,

Rick

Did you employ trim at neutral to center the servos? If so this the likely culprit... The TRIm offset deviation affects the throw in either direction. Simply increase or decrease the EPA percentage in either direction to equalize the two surfaces.

Splatz

08-15-2005 10:29 AM

RE: EPA and elevon mixing,

Thanks Michael,

I found out that I was only setting the EPA's at only one end of travel. All is well.

Rick O,

All times are GMT -8. The time now is 08:22 AM.