MikeVi

I'm trying to adjust the tranny to have a longer shift. The book says there are two screws inside the tranny and to not touch the top one. When I spin the spur and get the screw visible, I can only see one. Is that it?

MikeVi

Nvm. Found it. They make the one you need hardly accessible. Should I turn in 1/8 or 1/4 increments?

rclugnut10

My Feedback: (1)

they say 90 degree so that'ld be 1/4 but do what you want

the lug

Sparco

If its close to shifting to where you want do 1/8, if its wayyy off then 1/4 or even 1/2.