slipper nut to tight??
 

i just bought a robinson racing pinion gear and installed it. before installing it i tightened down the slipper nut. Then Iinstalled the pinion and put blue locktite on the set screw. when Ihit the throttle the set screw comes loose?? any suggestions?? the only thing Ican think of is the nut is possibly to tight?? it will run for 20 ft or so them come loose? it also rolls freely so its not binding.

RE: slipper nut to tight??
 

Just replace it if it won't stay tight

RE: slipper nut to tight??
 

Ijust replaced it and put locktite on it. so i will let it sit overnight and see what happens. its already late.but is it possible to overtighten the slipper nut??</p>

RE: slipper nut to tight??
 

loktight takes 24hrs 2 dry. it wont do any good unless its dry. & dont lock tight da slipper nut. just doublenut it.



xerxes alredy told u da slipper clutch is useless. tightn down as hard & far as it can go.

RE: slipper nut to tight??
 

I got the robinson racing slipper clutch its huge there is no way you are double nutting that thing! i will post pics tomorrow...the side of my bottle was worn out so i didnt see how long it took to dry. however, I will let it set. I really tightened the slipper nut down so I will keep an eye on it. Ialso ordered a castle parallel conector so Icould tone down the 6s and get a longer run time

RE: slipper nut to tight??
 

What about adding more washers?