Basic setup for helicopter
01-23-2005 | 04:02 PM
#1
Thread Starter
Junior Member
My Feedback: (1)
Joined: May 2004
Posts: 3
Likes: 0
Received 0 Likes
on
0 Posts
From: Strongsville,
OH
Basic setup for helicopter
I have had the Aerofly Pro for almost an year now but I haven't use it after the first few attempts. It is just too complicated to setup for me.
I use the Futabe Tx. I just can't seem to set it up appropriately, even when I follow the instructions.
I wonder if anyone in this forum can guide me through these mazes. Tell me, in the expert mode, which channels are for which functions, and which ones should be reversed.
Very frustrated!
Thanks,
SBK
I use the Futabe Tx. I just can't seem to set it up appropriately, even when I follow the instructions.
I wonder if anyone in this forum can guide me through these mazes. Tell me, in the expert mode, which channels are for which functions, and which ones should be reversed.
Very frustrated!
Thanks,
SBK
01-23-2005 | 04:30 PM
#2
Senior Member
My Feedback: (21)
Joined: Mar 2003
Posts: 9,227
Likes: 0
Received 0 Likes
on
0 Posts
From: Manhattan,
NY
RE: Basic setup for helicopter
Do your initial setup in basic mode.
Just choose new in controls and start fresh. Do not go into advanced mode until you are comfortable with it.
Just choose new in controls and start fresh. Do not go into advanced mode until you are comfortable with it.
