leopaul

When i start the engine, during the ramp my engine throw 2ft flames. I suspect that too much fuel is injected during ramp up. Do reducing the 3 ramp setting by 1 point will improve?

BluFox

My Feedback: (10)

Alex:

Please see email I posted to you. . .

Eric

extra 300

My Feedback: (3)

Presume we could all benefit from reply for above issue. Thanks sharing...

smitty1001

My Feedback: (29)

extra: these are setting adjustments in the ICS that have to be fine tuned. It is a set of keystrokes that Eric probably doesn't want to publish. Nothing more, nothing less. I'm sure the original poster spoke with Eric, lowered the fuel ramp and is flying happily by now without the flames on startup

leopaul

Do someone located close to sea level (500ft) could share with me all his startup parameters?

I would like to know the fuel ramp 1-2-3 value also if possible

Thanks!

BluFox

My Feedback: (10)

leopaul:

As I said in my email to you, all we must do is adjust "pump start point" and the flames are gone. Nothing else need be adjusted.

Please call during the week and we can adjust together.

Regards,
Eric

leopaul

This Rabbit is really boring,,,: After a few adjustements as per Eric request, here is always the same thing happening weekend after weekend:

- Fuel, start, fly, land....- Fuel, start, fly, land....- Fuel, start, fly, land.... Repeat as needed, my 3.5 first hours are done without any glitches..

RCISFUN

My Feedback: (44)

Judging by your post , I take it you are very satisfied with the Kero start Rabbit
And by boring you mean it is no longer has excessive flames.

CrocEnd

I have same prob. flames on start up have emailed Eric for Help
My Permit to Fly test is in two weeks les even.

BluFox

My Feedback: (10)

Hello:

Please check your email. . .I need further information for follow up and corrective procedure.

Regards,
Eric

CrocEnd

Eric

Pump PW Ignt. showing 32 is this to high that I get ball of flame before main or just on main igntion

Thanks Bob

BluFox

My Feedback: (10)

Hi:

Pump PW of 32 is not abnormal. . .The flames you report are during switch over and fuel ramp. . .correct? If so, we must make the pump start point less aggressive.

We need to connect by telephone M-F between the hours of 8:30 am and 6:00 pm my time in Florida. Have ECU battery charged, be at the turbine system with Tx and HDT available.

Regards,
Eric

CrocEnd

BINGO

Thanx Eric

NO more FLAME

Tried A0 first slow but ok
Next A2 much better
Third A3 good may try one more notch next weekend

all these tests NO FLAME

Cheer's Bob

BluFox

My Feedback: (10)

CrocEnd

You are very welcome.. . .you are a good student. Our tele call was productive and with good results. Thank you and enjoy your Rabbit ks.

Happy Holidays,

Eric

CrocEnd

Holiday's your not wrong from nock of time crisie for one mounth.

ain't there gona be so much kero fumes around

Did I say love it I DO

Bob