Bee II KS start-up phase is too long?
#1
Thread Starter
Join Date: Aug 2017
Posts: 4
Likes: 0
Received 0 Likes
on
0 Posts
Bee II KS start-up phase is too long?
Hello, i would like to apologize my bad English, I come from Germany. I have a Bee II Kerostart.
My problem:
I think the start-up phase is too long (over 70 seconds). For comparison I have 2 Rabbit and they have only half time of start-up phase.
I don't mean the acceleration time, I mean the ramp-up phase.
If the turbine has reached 55.00.RPM idle, then everything is ok.
I increased the pump start voltage from 035 step by step to 039 but then the turbine flames. I have now set 035 back again.
Terminal shows:
Runtime is 156m
V.6.18T
What else can I try? I would be grateful for a tip.
Many greetings
from Germany
Thomas
My problem:
I think the start-up phase is too long (over 70 seconds). For comparison I have 2 Rabbit and they have only half time of start-up phase.
I don't mean the acceleration time, I mean the ramp-up phase.
If the turbine has reached 55.00.RPM idle, then everything is ok.
I increased the pump start voltage from 035 step by step to 039 but then the turbine flames. I have now set 035 back again.
Terminal shows:
Runtime is 156m
V.6.18T
What else can I try? I would be grateful for a tip.
Many greetings
from Germany
Thomas