p160 Kerostart flames on startup
#1
Thread Starter
Join Date: Mar 2006
Location: Medford,
NJ
Posts: 228
Likes: 0
Received 0 Likes
on
0 Posts
p160 Kerostart flames on startup
I recently installed my kerostart unit on my p-160. Startups go well except for approx 5 sec it shoots flames out the tail pipe and the stops. This start soon after the main fuel starts pumping. All values are factory set values. Start fuel voltage 5.750 and initial main fuel voltage 0.50. I guess I could live with it,but it sounds like many have starts without any flame. I have 3 starts so far since adding kero.
docgboy
docgboy
#2
Member
Join Date: Feb 2003
Location: Barrie,
ON, CANADA
Posts: 52
Likes: 0
Received 0 Likes
on
0 Posts
RE: p160 Kerostart flames on startup
Perhaps you could lower the pump voltage slightly although it isn't really a problem anyway according to the info offered in the thread P60 A Few Questions... [link=http://www.rcuniverse.com/forum/m_4532757/tm.htm]HERE[/link]