P-120 Battery Harness Question
 

Hello all,
I've recently acquired a P120. I also have a P70. My P70 battery harness has 2 wires, however the P120 battery harness has 3 wires, red, white and black, with a red rectangular connector on one end, and green rectangular connector on the other end that connects to the ECU. I cannot find a manual online that describes how the 3 wires are connected. Can I cut the red end off and attach an EC5 connector? If so, I assume red is +, black is - but what about the white wire? Do I need to use the stock red connector? If so, where can I get the end that connects to the battery?

Thanks in advance,
-Jorden
https://cimg7.ibsrv.net/gimg/www.rcu...f6b9a9396f.jpg

No. Positive and Negative only.
Those wires are too small too if they are battery. You sure that’s not the turbine-ECU lead? Battery would have female and that is make.

D

Dave, thanks for your reply.
Here are several pics of what I have. I know I'm missing the LED board and the GSU. When I received the ECU, the wires were connected as shown. Hopefully these pics make sense.
https://cimg8.ibsrv.net/gimg/www.rcu...70fc35908f.jpg
https://cimg9.ibsrv.net/gimg/www.rcu...9d79969681.jpg
https://cimg0.ibsrv.net/gimg/www.rcu...6f305d9a7b.jpg
https://cimg2.ibsrv.net/gimg/www.rcu...de3b4b54ea.jpg
https://cimg3.ibsrv.net/gimg/www.rcu...fbd6707a44.jpg
https://cimg6.ibsrv.net/gimg/www.rcu...b9a8ebfeee.jpg
https://cimg4.ibsrv.net/gimg/www.rcu...cd9e2049f0.jpg

https://cimg7.ibsrv.net/gimg/www.rcu...2614c08003.jpg
https://cimg8.ibsrv.net/gimg/www.rcu...863b34ff9f.jpg
https://cimg9.ibsrv.net/gimg/www.rcu...51944a6894.jpg
https://cimg0.ibsrv.net/gimg/www.rcu...f62853581b.jpg

Non-OEM
 

That is a homemade battery adapter, and not supplied by Jetcat. If you look at the battery connector (green MPX) plugged into the ECU, the red & white wires are "+" and black wire is "-" (using two center pins only). I would throw that adapter in the trash and get a proper battery with MPX connector already attached, or make the proper adapter.

Thanks!