How to get DX8 to read gear/flap servos?
10-31-2011, 05:31 AM
#1
Senior Member
Thread Starter
My Feedback: (2)
Join Date: Aug 2003
Location: Blythewood,
SC
Posts: 1,256
Likes: 0
Received 0 Likes
on
0 Posts
How to get DX8 to read gear/flap servos?
Hi all,
I bought the DX8 and installed into my FMS Trojan. However, I could not get the gear/flaps to operate! I even changed frame rates to no avail. They worked fine with my 9303 before I sent the TX in for repair. Thanks DP
I bought the DX8 and installed into my FMS Trojan. However, I could not get the gear/flaps to operate! I even changed frame rates to no avail. They worked fine with my 9303 before I sent the TX in for repair. Thanks DP
11-01-2011, 09:50 PM
#2
Senior Member
RE: How to get DX8 to read gear/flap servos?
First, do the gear and flap channels show up on the TX monitor screen as changing when you flip the gear or flap switches?
next, since this is FMS, what settings are you using at the "joystick" interface.
The channel order may be different that the previous TX. I assume that the Trojan emulation includes gear & flaps.
(Some of the PZ model em's don't.
next, since this is FMS, what settings are you using at the "joystick" interface.
The channel order may be different that the previous TX. I assume that the Trojan emulation includes gear & flaps.
(Some of the PZ model em's don't.
