Kingtech K-45G4+
02-20-2023, 09:53 AM
#1
Thread Starter
Join Date: Nov 2005
Location: Norway, NORWAY
Posts: 61
Likes: 0
Received 0 Likes
on
0 Posts
Kingtech K-45G4+
Hello.
I have a new turbine with a annoying problem.
Every first start it stops when i reach half trottle.
When i start it up again everything is ok
.
The turbine have only used about 3 litre of fuel.
Kingtech oil and Jet A1.
Any suggestion?
Kind Regards
Lars
Norway
I have a new turbine with a annoying problem.
Every first start it stops when i reach half trottle.
When i start it up again everything is ok
.The turbine have only used about 3 litre of fuel.
Kingtech oil and Jet A1.
Any suggestion?
Kind Regards
Lars
Norway
02-20-2023, 09:56 PM
#2
Join Date: Sep 2011
Location: InCheon, SOUTH KOREA
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Hello.
I have similar problem.
my K45m G4+ turbine always stop at half throttle when I elevate throttle slowly.
but when I stick up rapidly to full throttle, It runs well.
so. I asked Kingtech TW. and waiting for answer.
I have similar problem.
my K45m G4+ turbine always stop at half throttle when I elevate throttle slowly.
but when I stick up rapidly to full throttle, It runs well.
so. I asked Kingtech TW. and waiting for answer.
02-20-2023, 11:11 PM
#4
Join Date: Sep 2011
Location: InCheon, SOUTH KOREA
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
I'm looking for that issue, and I found this.
check facebook
"KingTech Turbine Owner"
This problem is not rare problem, see the post 5th Jan.
the solution is bring back the turbine to kingtech service
check facebook
"KingTech Turbine Owner"
This problem is not rare problem, see the post 5th Jan.
the solution is bring back the turbine to kingtech service
02-22-2023, 07:02 PM
#5
Join Date: Sep 2011
Location: InCheon, SOUTH KOREA
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
I fixed my K45 G4.
I recieved mail from Kingtech TW. They said increase "Acceleration delay" value, but it's useless.
I changed trubine positon to upside down and it works perfectly.
I set my turbine plug side up and No flame out.
Maybe it's some effect that fuel pump has break in during test because I testes over 25 times.
anyway my turbine run well now.
I recieved mail from Kingtech TW. They said increase "Acceleration delay" value, but it's useless.
I changed trubine positon to upside down and it works perfectly.
I set my turbine plug side up and No flame out.
Maybe it's some effect that fuel pump has break in during test because I testes over 25 times.
anyway my turbine run well now.
