Learn RC Problem
I have a JETI DS12 and a KT-800 turbine helicopter.
I cannot get the ECU to accept a low trim setting to stop the turbine. It also wants to start the turbine at the last step of Learn RC so I quickly disconnect power. I can start the turbine but cannot stop it unless I let it run out of fuel. GSU reads TH:IDLE. Any suggestions would be appreciated. |
My Learn RC problem is solved.
|
All times are GMT -8. The time now is 02:35 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.