Learn RC Problem
10-06-2022 | 05:33 PM
#1
Thread Starter
Joined: Mar 2017
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
Learn RC Problem
I have a JETI DS12 and a KT-800 turbine helicopter.
I cannot get the ECU to accept a low trim setting to stop the turbine.
It also wants to start the turbine at the last step of Learn RC so I quickly disconnect power.
I can start the turbine but cannot stop it unless I let it run out of fuel.
GSU reads TH:IDLE.
Any suggestions would be appreciated.
I cannot get the ECU to accept a low trim setting to stop the turbine.
It also wants to start the turbine at the last step of Learn RC so I quickly disconnect power.
I can start the turbine but cannot stop it unless I let it run out of fuel.
GSU reads TH:IDLE.
Any suggestions would be appreciated.
