balancing ultimate with swept back wing
01-29-2015, 08:13 AM
#1
Thread Starter
My Feedback: (12)
Join Date: Dec 2001
Location: Yellow Springs,
OH
Posts: 389
Likes: 0
Received 0 Likes
on
0 Posts
balancing ultimate with swept back wing
I am confusing myself on balancing my goldberg ultimate. I blueprints show the balance point being 2.5in back from the leading edge. If that measurement is taken at the very center of the wing with the wing being a swept wing the measurement would not be the same at the sides of the fuse where my balancer pads rest. Am I right in my thinking? It might be 1.5 inches 4inches out from the centerline of the wing with the way the wing swept back. I just need to confirm my thinking.
thanks
Jeff
thanks
Jeff
