Sig 1/4 J-3 Cub
11-05-2004 | 07:00 PM
#1
Thread Starter
Joined: Jul 2003
Posts: 73
Likes: 0
Received 0 Likes
on
0 Posts
From: Poinciana,
FL
Sig 1/4 J-3 Cub
I am about to start the Sig 1/4 J-3 cub and would like to make the wings fully removeable from the center section using a nested aluminun tub.
Has any one done this and if so can you let me know how it turned out and how you did it.
Joe
Has any one done this and if so can you let me know how it turned out and how you did it.
Joe
11-05-2004 | 09:34 PM
#2
My Feedback: (1)
RE: Sig 1/4 J-3 Cub
ORIGINAL: njrcflyer
I am about to start the Sig 1/4 J-3 cub and would like to make the wings fully removeable from the center section using a nested aluminun tub.
Has any one done this and if so can you let me know how it turned out and how you did it.
Joe
I am about to start the Sig 1/4 J-3 cub and would like to make the wings fully removeable from the center section using a nested aluminun tub.
Has any one done this and if so can you let me know how it turned out and how you did it.
Joe
