i have great planes engine mount for my eagle, but do i need to get a break away plate so the engine is set at the right angle or is the great planes mount ok?

i have an eagle i recently built... what size is yours? did you install the break away plate mounting rails? I believe the mount will be set at 0 degrees so you will have to put some spacers to give it the down and right thrust.

the rails are there. what would i be able to use as spacers? could i use washers, or wood?

washers is what i see on most instructions. Is there a reason you don't want to use the stock mount?

i dont have one.

OH!
Well it's really easy to fabricate. Let me know if you don't have the plans and i can send you a copy of that part or the specs if you need them. It will be a lot easier in the end than trying to adapt the engine mount. But if you really want to use the engine mount, then washers will do the trick.

yes, please send me the plans. the mount is causing me headaches with the front landing gear.

ok, i will bring it to work tomorrow and scan the break away plate with the dimensions and i can email it to you. Or if you want me to mail you a hard copy let me know. If you want to full plans, i will have to find out where they can make copies of them?

just that one part is fine. ill pm you my email. thanks.