Using Oracover to cover a canopy?
06-07-2003 | 01:35 PM
#1
Thread Starter
Senior Member
Using Oracover to cover a canopy?
I have a smoked caopy that I would like to cover. Is it possible to use Oracover (aka profilm I think) To colour it? Or do I have to use some other method, like painting?
Thanks,
Robert.
(Plane is a Synergy 90 3D at www.znline.com )
Thanks,
Robert.
(Plane is a Synergy 90 3D at www.znline.com )
06-07-2003 | 04:17 PM
#2
Senior Member
My Feedback: (3)
Joined: Nov 2002
Posts: 20,205
Likes: 0
Received 20 Likes
on
15 Posts
From: Mary Esther, Florida, FL
Using Oracover to cover a canopy?
Robert:
Just scuff it with some 600 paper and paint it.
To get film to comply with the curvature of the canopy you'll get the temperature very close to the point where the canopy will collapse.
Painting is easy and SO much safer.
Bill.
Just scuff it with some 600 paper and paint it.
To get film to comply with the curvature of the canopy you'll get the temperature very close to the point where the canopy will collapse.
Painting is easy and SO much safer.
Bill.
