RCU Forums - 4* wing question

RCU Forums (https://www.rcuniverse.com/forum/)

- Kit Building (https://www.rcuniverse.com/forum/kit-building-121/)

- - 4* wing question (https://www.rcuniverse.com/forum/kit-building-121/1600324-4%2A-wing-question.html)

msu68stang

03-07-2004 05:55 PM

4* wing question

OK I'm to the point of drilling the on the front of the wing on the four star for the dowel. What's the best way to go about this. I've had problem getting the drill to stay centered. I guess the problem could be that I used some 2000lb strength epoxy and it just too hard to drill. What suggestions do you guys have.

SgtMitchell

03-07-2004 07:57 PM

RE: 4* wing question

Try starting out with a very small drill bit and increase the size until you get the hole to accept the dowel rod

msu68stang

03-07-2004 07:59 PM

RE: 4* wing question

you know now that you say that it make complete sense and is usually something i would do. *bang head on table* think think think :D

All times are GMT -8. The time now is 10:33 PM.