|
spinner
Can anybody direct me to a company who has a 3" spinner that will fit a 6mm shaft on a Hacker motor?
cas |
spinner
CAS:
Most spinners have a set diameter hole in them, and have bushings supplied for shaft size selection. As you know, 6mm is just a hair smaller than 1/4" and you could probably use a pape shim wrapped around the prop shaft to make the 1/4" bushing fit nicely. The props are mostly 1/4" anyway. Bill. |
| All times are GMT -8. The time now is 02:48 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.