throws for a midwest giles.
just wonderin if anyone can dig up the manual for a midwest giles and find out the factory control throws on it.
ive heard there a little on the mild side but its a place to start.also been told if u got too much throw on the elevator it could be disasterous. any input would help,thanx its the 74 in 27% size mv-warbird |
RE: throws for a midwest giles.
Factory I don't know but I use A degree meter and set up my stunt planes for 12 and 18 degrees for high and low as my starting point then trim the plane the way I like it after each flight. It's A good starting point.
|
RE: throws for a midwest giles.
The factory throws are as follows;
Ailerons: Hi Rate 3/4in in Low Rate 9/16in Elevator: Hi Rate 1 1/4in Low Rate 13/16in Rudder: Hi rate 3/4in Low rate 1/2in Be careful with Hi Rate elevator, the plane is inherently "snappy" at Hi speed. Good luck, Joe |
All times are GMT -8. The time now is 06:12 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.