MidWest Pitts Canopy
 

I got a Midwest Pitts Super Stinker with a Brison 2.4 that I built and have[:o] been flying since '03. Two weekends ago, the canopy split while in flight. Any ideas where to get a replacement? I contacted MidWest and they do not have parts.

RE: MidWest Pitts Canopy
 

Fiberglass Specialties.

RE: MidWest Pitts Canopy
 

Craig,

Thanks for the thought! When I contacted Midwest, they suggested Fiberglass Specialties. I contacted them (copied below) and they do not have the canopy.

Hello,
Thank you for contacting us. Unfortunately we do not have the plug to make this canopy and I don’t know of anyone that does. Sorry.
Thanks again for checking with us.
Craig


IF REPLYING, PLEASE DO NOT DELETE ANY PART OF THIS EMAIL.

Craig Schmidt
Fiberglass Specialties
15715 Ashmore Dr.
Garfield, Arkansas 72732
(479) 359-2429
(479) 359-2259 fax
www.fiberglassspecialtiesinc.com

RE: MidWest Pitts Canopy
 

When I build an old kit or a plane from plans sometimes I have to go look at the ARFs of the same plane and find one of about the same size and buy one of theres. Last one was a little 60 size Extra 260 and I found a canopy from Segul that fit with just a bit of cutting. It was so much cheaper then the one I found at FS that I bought three of them to keep in my shop. Even looked good on the 4* 60. Looks like you may have to do the same thing.