LMH Corona 120 Rotor RPM
08-10-2006, 06:41 PM
#1
Senior Member
Thread Starter
My Feedback: (1)
Join Date: Nov 2004
Location: murrieta,
CA
Posts: 158
Likes: 0
Received 0 Likes
on
0 Posts
LMH Corona 120 Rotor RPM
What RPM is everyone using? My Corona 120 is running @ 1600 rpm at lift off which seems a little slow. Currently I have 2 & 4 degree blade holders running off a JGF 400, belt drive system on a 1800 3cell/25c/lipo (40 oz total weight). I was running about 1400 rpm with 4 & 4 degree blade holders. When my other 2 degree blade hold arrives I'll install and check again. It's a little hard to hover which might be attributed to the low head speed......Also running 60% expo on both ail & ele (JR six channel)
