RCU Forums - Conversation Between gary3173 and Aussie Maddog

Go Back  RCU Forums > gary3173
Reload this Page >

Conversation Between gary3173 and Aussie Maddog

Notices
Conversation Between gary3173 and Aussie Maddog
Showing Visitor Messages 1 to 5 of 5
  1. Aussie Maddog
    03-30-2019 11:27 AM
    I can't seem to upload pics here.
    This is what it tells me your email address is "[email protected]"
    I receive this fault:

    Address not found

    Your message wasn't delivered to [email protected]because the address couldn't be found, or is unable to receive mail.
  2. Aussie Maddog
    03-30-2019 11:20 AM
    Hello Gary, I received your email fine, but could not reply.

    Hello Gary,
    I have 3 modules you can have. (All for 10mm plugs)I have not flown rc or played with engines for 10 yrs now so I cannot remember much about them. One has "SUS" written on it so it may not work.
    I have a heap of hall sensors with different mounts and brackets also. Manual Kill switches (3) & new great planes switch & charge mounts (2)
    Note: There is no mounting ring for the hall sensor to to the G2300 engine.
    Back when I did this, there was no rc ignition modules to fit the 1/4 sparkplug so I went with the 10mm cm6 type. From memory, I had to mount a spacer (washer)under the plug so it didn't sit too deep.
    I'm happy to add everything in the pics. As the engine by itself weighs 1.48 kgs, it sits just under the 1.5 kg shipping rate. With the modules etc it goes up into the 2 kg rate. So I need to ask for 10 USD extra to cover the extra shipping. So $180 usd all up.
    Regards,
    Rhett
  3. Aussie Maddog
    03-30-2019 07:57 AM
    Hello Gary, The reply to your email keeps bouncing. ....tried 3 times.
  4. Aussie Maddog
    03-29-2019 06:19 PM
    Hello Gary,
    I can do $170 USD including tracked shipping by direct paypal payment to [email protected]
    (or I can invoice your paypal)
    Regards,
    Rhett Mitchell
  5. 03-29-2019 10:08 AM
    Ok will try to message you here instead of EBAY

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.