RCU Forums - View Profile: sheograth

Go Back  RCU Forums >
Reload this Page >

sheograth's Profile

Notices

sheograth sheograth is offline

Moderator

About Me

  • About sheograth
    Location
    Berkeley, CA
    Interests
    Vehicles of all sorts, Engineering, Physics, Sciences, Nature, Cosmology, History, Politics.......
  • Signature
    RCUniverse.com | Wattflyer.com | RCUvideos.com

Statistics

Total Posts
Visitor Messages
Total Likes
General Information
  • Last Activity: 09-25-2016 07:51 AM
  • Join Date: 06-10-2007

Visitor Messages

Showing Visitor Messages 1 to 2 of 2
  1. sheograth
    08-26-2016 03:43 PM
    Sounds like your throttle servo is messed up or the radio signal isn't good. A non broken in engine or carb shouldn't go totally run-away.
  2. 08-13-2016 02:07 PM
    Hi, I just tried to run my Losi DBXL to break it in, but when it starts, it runs away. According to the manual, I should not adjust the carb settings until after it has been broken in. Why is it running away? What can I do to prevent it from running away? It should just idle at a still position, shouldn't it?
    Thank you.

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.