I need some help
02-12-2017, 11:04 AM
#1
Thread Starter
Join Date: Jan 2006
Location: houston,
TX
Posts: 142
Likes: 0
Received 0 Likes
on
0 Posts
I need some help
I'm new to drones/quads.
I've been flying a Tiny Whoop and a Blade Inductrix 200 using a Fat Shark Attitude V3.
I'm trying to move up to racing drones so I bought a Rise RSX270.
It uses some open source control software named Librepilot.
My son programed it all and I had it flying fairly well. (line of site)
Today I wanted to increase it's self leveling and I made some changes.
NOW,
It flys fine when I 1st take off. Then it starts leaning forward and I have to compensate with my elevator stick.
This gets worse and worse while it's in the air until I'm at full up elevator and I can't stop forward motion.
I land, and it seems to reset itself and then does it all over again.
It's like the gyro starts out level and then drifts out and tilts the quad forward by itself.
????????????????????????
thx,
Jim
I've been flying a Tiny Whoop and a Blade Inductrix 200 using a Fat Shark Attitude V3.
I'm trying to move up to racing drones so I bought a Rise RSX270.
It uses some open source control software named Librepilot.
My son programed it all and I had it flying fairly well. (line of site)
Today I wanted to increase it's self leveling and I made some changes.
NOW,
It flys fine when I 1st take off. Then it starts leaning forward and I have to compensate with my elevator stick.
This gets worse and worse while it's in the air until I'm at full up elevator and I can't stop forward motion.
I land, and it seems to reset itself and then does it all over again.
It's like the gyro starts out level and then drifts out and tilts the quad forward by itself.
????????????????????????
thx,
Jim
