RCU Forums - Configuring UART2/I2C on APM 2.8

RCU Forums (https://www.rcuniverse.com/forum/)

- Multi-rotor Electronics (https://www.rcuniverse.com/forum/multi-rotor-electronics-546/)

- - Configuring UART2/I2C on APM 2.8 (https://www.rcuniverse.com/forum/multi-rotor-electronics-546/11682131-configuring-uart2-i2c-apm-2-8-a.html)

Dmpanhead

08-27-2020 02:36 PM

Configuring UART2/I2C on APM 2.8

Does anyone know how to configure UART2 on an APM 2.8 board? I need Tx, RX, +5v and ground. I would need pin out and board mods and possibly firmware/software mods

All times are GMT -8. The time now is 10:10 AM.