Configuring UART2/I2C on APM 2.8
08-27-2020 | 02:36 PM
#1
Thread Starter
My Feedback: (1)
Joined: Mar 2009
Posts: 12
Likes: 0
Received 0 Likes
on
0 Posts
From: Farmingdale,
NJ
Configuring UART2/I2C on APM 2.8
Does anyone know how to configure UART2 on an APM 2.8 board? I need Tx, RX, +5v and ground. I would need pin out and board mods and possibly firmware/software mods
