Go Back  RCU Forums > RC Helicopters > Multi Rotor Helicopters
Reload this Page >

Cannot get AeroSky 550 to fly

Notices
Multi Rotor Helicopters Discuss Multi rotor RC Helicopter's here!

Cannot get AeroSky 550 to fly

Old 02-24-2015, 05:16 PM
  #1  
nom_carver
Junior Member
Thread Starter
 
Join Date: Feb 2015
Posts: 1
Likes: 0
Received 0 Likes on 0 Posts
Default Cannot get AeroSky 550 to fly

We are having trouble getting the AeroSky 550 hexacopter to fly. We purchased the ready-to-fly version, assembled it, and loaded MultiWii 2.2 on it using the Arduino IDE. However, the rotors do not spin when we attempt to arm the hexacopter. We have taken apart the body and determined that the wiring is correct. The voltage levels change on the receiver pins when we change the transmitter inputs, so we are sure that the transmitter is working. What could be the problem?


EDIT: We've also wired the ESC inputs directly to the receiver, and they do spin when the throttle is on, so it isn't a hardware issue. Does anyone know what might be wrong in our MultiWii setup? All we did was enable some of the #defines in the config.h file.

Last edited by nom_carver; 02-25-2015 at 09:58 AM.

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.