Oscillating air engine
01-26-2006 | 07:17 AM
#1
Thread Starter
Member
Joined: Jul 2005
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
From: Sydney, AUSTRALIA
Oscillating air engine
Here's a little engine I made recently with a rapid prototype machine that I run. Some of the steam engine fans might find it interesting.
[link=http://www.users.on.net/~maxtmp/model/]Model page[/link]
[link=http://www.users.on.net/~maxtmp/model/]Model page[/link]
03-16-2006 | 05:59 AM
#4
Thread Starter
Member
Joined: Jul 2005
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
From: Sydney, AUSTRALIA
RE: Oscillating air engine
It is pretty good 
I'm actually looking at making some investment castings for parts they don't make anymore. I have modeled a crank case backing for an
old motor that I hope to cast one day. I have also thought about making some of my own pilots, but I still have some learning to do with the 3d software.
Our machine is an Objet 330 that uses the inkjet type technology. There are a few lithography machines now, if I may ask which does yours use?
PS sorry for my late reply, I'd forgotten I'd posted this one.
I'm actually looking at making some investment castings for parts they don't make anymore. I have modeled a crank case backing for an
old motor that I hope to cast one day. I have also thought about making some of my own pilots, but I still have some learning to do with the 3d software.
Our machine is an Objet 330 that uses the inkjet type technology. There are a few lithography machines now, if I may ask which does yours use?
PS sorry for my late reply, I'd forgotten I'd posted this one.
