Trainer after using JR PC data Interface 9303
06-13-2008 | 03:45 PM
#1
Thread Starter
Joined: Oct 2006
Posts: 188
Likes: 0
Received 0 Likes
on
0 Posts
From: Grand Paririe,
TX
Trainer after using JR PC data Interface 9303
I have a JR 9303 2.4 and been working fine.
I got the new JR PC Data Interface and after using it to save all model settings my transmitter now says "Trainer" where it used to say in big letter "JRPRO".
Ive tried everything and cant get it to go away, JR has no idea and said to send it in for service.
HAs this happened to anyone else , I need to know for sure if the Data Interface is why this happened, I cant figure any other cause as i did nothing else.
Dave
I got the new JR PC Data Interface and after using it to save all model settings my transmitter now says "Trainer" where it used to say in big letter "JRPRO".
Ive tried everything and cant get it to go away, JR has no idea and said to send it in for service.
HAs this happened to anyone else , I need to know for sure if the Data Interface is why this happened, I cant figure any other cause as i did nothing else.
Dave
06-18-2008 | 12:18 AM
#2
Thread Starter
Joined: Oct 2006
Posts: 188
Likes: 0
Received 0 Likes
on
0 Posts
From: Grand Paririe,
TX
RE: Trainer after using JR PC data Interface 9303
Well after days of playing and doing everything i could think of I got it back to normal.
I plugged in and out a trainer cord and wiggled it....... So now i think its either a defective trainer jack or software bug.
If you run into the same problem PLEASE let me know
Dave
I plugged in and out a trainer cord and wiggled it....... So now i think its either a defective trainer jack or software bug.
If you run into the same problem PLEASE let me know
Dave
