My New Flying Wing
#1
Member
Thread Starter
My Feedback: (1)
Join Date: Jun 2003
Location: Pueblo West ,
CO
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
My New Flying Wing
Here is a picture of my latest flying wing creation. It is CNC cut out of Pink Foam. It features a hollow wing. This one is covered in low temp iron on film. A two meg video clip can be downloaded at the following site. I call it Fight Master Foamy.
http://www.modelbridges.com/FM/FM.zip
The video shows the very first prototype that was made out of White Foam.
John Boren
http://www.modelbridges.com/FM/FM.zip
The video shows the very first prototype that was made out of White Foam.
John Boren
#3
Member
Thread Starter
My Feedback: (1)
Join Date: Jun 2003
Location: Pueblo West ,
CO
Posts: 50
Likes: 0
Received 0 Likes
on
0 Posts
Motor Type
I have mainly flown the wing on GW EPS 300 gear drives. I have also flown a couple flights with a 7.2 Volt Speed 400 direct drive motor. Next I want to try a 6 Volt Speed 400 direct drive and then lastly a MP Jet 25/35-20 brushless setup. I have just finished making some kits if any one is interested in them after viewing the video.
John Boren
John Boren