Medusa 3.5A BEC Labeling Issue
 

It has come to our attention (which was verified after an internal investagation) that there have been a few 3.5A BEC's shipped to customers and dealers with the label on backwards.

If you happen to get one of these units, just remember that:

1) the wire with the connector plugs into your receiver
2) the wire with the tinned ends connects to your ESC plug that connects to the battery

as described in the manual.

If there are any questions or concerns, please contact us by email or phone.


Regards,

MRI

RE: Medusa 3.5A BEC Labeling Issue
 

I'm pretty sure I'm the one who brought the reversed labels on the input and output wires to their attention. It is VERY important that you pay close attention to the advice given by MRI above !

My (expensive) [link=http://www.rcuniverse.com/forum/m_5323469/tm.htm]tale of woe [/link] is here along with some pictures.