Medusa 3.5A BEC Labeling Issue
#1
Junior Member
Thread Starter
Join Date: Mar 2005
Location: Fall River,
MA
Posts: 8
Likes: 0
Received 0 Likes
on
0 Posts
Medusa 3.5A BEC Labeling Issue
It has come to our attention (which was verified after an internal investagation) that there have been a few 3.5A BEC's shipped to customers and dealers with the label on backwards.
If you happen to get one of these units, just remember that:
1) the wire with the connector plugs into your receiver
2) the wire with the tinned ends connects to your ESC plug that connects to the battery
as described in the manual.
If there are any questions or concerns, please contact us by email or phone.
Regards,
MRI
If you happen to get one of these units, just remember that:
1) the wire with the connector plugs into your receiver
2) the wire with the tinned ends connects to your ESC plug that connects to the battery
as described in the manual.
If there are any questions or concerns, please contact us by email or phone.
Regards,
MRI
#2
Junior Member
Join Date: Feb 2005
Location: mooresville,
NC
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
RE: Medusa 3.5A BEC Labeling Issue
I'm pretty sure I'm the one who brought the reversed labels on the input and output wires to their attention. It is VERY important that you pay close attention to the advice given by MRI above !
My (expensive) [link=http://www.rcuniverse.com/forum/m_5323469/tm.htm]tale of woe [/link] is here along with some pictures.
My (expensive) [link=http://www.rcuniverse.com/forum/m_5323469/tm.htm]tale of woe [/link] is here along with some pictures.