Should arrive at home a week or two before I get up there to start working on it (no space down here)

Anyone have any pictures of their pull/pull setup's before they sheeted? im curious as to how you guys do the routing of the entrance/exit tubes on the top sheet

Jeff went to a lot of trouble when writing the instructions for the Sledge to make the pull pull installation user friendly.
Its explained really well.

Ok, I give..who makes the Sledge? Thanks, JT

The Sledge 540 was designed by Jeff Williams of Indiana. Jeff sold his design to Morris Hobbies, which manufactures and sells the Sledge 540 kit.
Hope that this helps you out.
Kevin

Thanks Kevin,
Thinking of getting a profile, they look like they'd be alot of fun. I've read about the Knife, Not sure which way to go yet. JT

JT, since you are located in Northern Indiana, and Jeff Williams resides in Greenville, IN, you ought to email him and meet up with him and check out the Sledge for yourself. You can email Jeff at:
[email protected] Believe me, he doesn't mind. I know he has been having trouble logging onto RCU, so he may not see this post. Just tell him that I sent you. We are good friends.
Kevin