HurriKane Questions
#1
Junior Member
Thread Starter
My Feedback: (18)
Join Date: Sep 2002
Location: Stamford,
CT
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
HurriKane Questions
I got my kit yesterday. I was a little surpised to see that I had to join the composite wing together,cut out the ailerons, and install the horns. I'm used to receiving composite wings with all of that already done. Anyway, what is the best method for joining the wing? There is a carbon tube as a wing joiner in the box but the cores are hollow at the ends. There doesn't seem to be alot of area to glue together at the center section.
#2
Join Date: Jun 2002
Location: Arlington Heights,
IL
Posts: 408
Likes: 0
Received 0 Likes
on
0 Posts
RE: HurriKane Questions
Joe, I will try to call you this afternoon.
For those that are interested. SuperTRC has two sources for the HurriKane wing. One source is Bruce DeChastel, and the second is Lyle Larson. Lyle sends us wings that are 1 pc. Bruce sends us wings that are in two pcs. due to the shipping cost from Australia.
I am currently flying the HurriKane in it's two pc wing configuration. This is the same method that is being used on the Polecat and most recently on Bruce's F3D evolution. In addition to these faster models all of variants of the shot gun use the same method.
In terms of installing the horns. I will try to post pictures tonight.
Sorry for the confusion,
Dan
For those that are interested. SuperTRC has two sources for the HurriKane wing. One source is Bruce DeChastel, and the second is Lyle Larson. Lyle sends us wings that are 1 pc. Bruce sends us wings that are in two pcs. due to the shipping cost from Australia.
I am currently flying the HurriKane in it's two pc wing configuration. This is the same method that is being used on the Polecat and most recently on Bruce's F3D evolution. In addition to these faster models all of variants of the shot gun use the same method.
In terms of installing the horns. I will try to post pictures tonight.
Sorry for the confusion,
Dan