Wire question
10-20-2010 | 08:15 AM
#1
Thread Starter
Senior Member
My Feedback: (4)
Joined: Feb 2009
Posts: 384
Likes: 0
Received 0 Likes
on
0 Posts
From: Anderson,
SC
Wire question
I have a on board glow plug starter by Sullivan and need to lengthen the two wires to the motor. The instructions say to use high temp wires. Where do I get these type of wires?
10-20-2010 | 01:33 PM
#3
My Feedback: (158)
RE: Wire question
Or an Auto Supply store,,
But really, I'd just make the splice as far away from the plug as posible, leaving as much of the OEM wire as you can near the engine, You should be fine with normal type wire as long as you route it so it not very near the exhaust. How long is that OEM lead anyway?
good luck
But really, I'd just make the splice as far away from the plug as posible, leaving as much of the OEM wire as you can near the engine, You should be fine with normal type wire as long as you route it so it not very near the exhaust. How long is that OEM lead anyway?
good luck
