I have one of Hi-Techs 3x gyros and want to set it up on the 3 position switch (I think it;s switch C) on my 9C with 2.4 conversion. I am using a Futaba 7 channel receiver. can someone tell me in easy terms how to assign this switch for this.
Thanks

Just curious, why the three position switch?

To assign the switch, go to the "AUX-CH" menu, pick which ever channel you wish to use, toggle until the switch you want is shown, exit the menu

good luck

Kat
why a gyro?

Why not a gyro?

Because there maybe cheaper ways to get the same results unless he's flying some exotic airplane like a night hawk

Probably a helicopter

Who cares why,, guy has a programming question, he doesn't need psychoanalysis, just an answer to the programming question

Scale:
did you read what I said about a cheaper way to get the same results?

Yes, did you read the OP where it says this you're a little late

Let's not turn this into gyro debate, he has one, someone told him how to configure it, lets move on

It's not the gyro Andy. It's the attitude. I ask a simple question.